B1264 Code: Meaning, Symptoms, Causes & Fix

Overview

B1264 is triggered when monitoring logic identifies an issue with Servo Motor Foot Circuit Failure affecting body electronics and comfort modules.

Symptoms

feature inoperative intermittently
module resets or glitches
related warning lamp illuminated

Common causes

Disconnected or loose connector affecting servo motor foot circuit failure
Open circuit in wiring
Connector pin damage/corrosion or harness stress near related components

How to diagnose B1264

Confirm B1264 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to servo motor foot circuit failure for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1264

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1264?

Most vehicles can be driven short-term with B1264, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the servo motor foot circuit failure circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify B1264 remains cleared under the conditions that originally set the code.

Fix options

Repair open circuit and secure connector lock.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1264

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

B1264 in common vehicles

B1264 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1264?

B1264 is commonly set by open faults affecting servo motor foot circuit failure.

How much does it cost to fix B1264?

For B1264, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1264 without repair?

You can clear B1264 temporarily, but the code usually returns until the underlying fault is corrected.