B1297 Code: Meaning, Symptoms, Causes & Fix

Overview

B1297 is triggered when monitoring logic identifies an issue with Power Supply Sensor Circuit Open affecting body electronics and comfort modules.

Symptoms

battery draw complaints
related warning lamp illuminated
module resets or glitches

Common causes

Broken terminal inside harness affecting power supply sensor circuit open
Open circuit in wiring
Connector pin damage/corrosion or harness stress near related components

How to diagnose B1297

Confirm B1297 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to power supply sensor circuit open for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1297

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1297?

Most vehicles can be driven short-term with B1297, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the power supply sensor circuit open circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify B1297 remains cleared under the conditions that originally set the code.

Fix options

Restore continuity and verify pin tension.
Repair open circuit and secure connector lock.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1297

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

B1297 in common vehicles

B1297 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1297?

B1297 is commonly set by open faults affecting power supply sensor circuit open.

How much does it cost to fix B1297?

For B1297, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1297 without repair?

You can clear B1297 temporarily, but the code usually returns until the underlying fault is corrected.