B1376 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• related warning lamp illuminated
• battery draw complaints
• feature inoperative intermittently

Common causes

• Open circuit in wiring affecting oil change lamp circuit short to battery
• Broken terminal inside harness
• Connector pin damage/corrosion or harness stress near related components

How to diagnose B1376

1. Confirm B1376 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to oil change lamp circuit short to battery for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1376

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1376?

Most vehicles can be driven short-term with B1376, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the oil change lamp circuit short to battery circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify B1376 remains cleared under the conditions that originally set the code.

Fix options

• Clear corrosion and protect terminals.
• Restore continuity and verify pin tension.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1376

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

B1376 in common vehicles

B1376 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1376?

B1376 is commonly set by open faults affecting oil change lamp circuit short to battery.

How much does it cost to fix B1376?

For B1376, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1376 without repair?

You can clear B1376 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost