B1660 Code: Meaning, Symptoms, Causes & Fix

Overview

B1660 is triggered when monitoring logic identifies an issue with Seat Driver Front Up Circuit Open affecting body electronics and comfort modules.

Symptoms

feature inoperative intermittently
module resets or glitches
related warning lamp illuminated

Common causes

Broken terminal inside harness affecting seat driver front up circuit open
Disconnected or loose connector
Connector pin damage/corrosion or harness stress near related components

How to diagnose B1660

Confirm B1660 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to seat driver front up circuit open for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1660

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1660?

Most vehicles can be driven short-term with B1660, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the seat driver front up circuit open circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify B1660 remains cleared under the conditions that originally set the code.

Fix options

Restore continuity and verify pin tension.
Clear corrosion and protect terminals.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1660

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

B1660 in common vehicles

B1660 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1660?

B1660 is commonly set by open faults affecting seat driver front up circuit open.

How much does it cost to fix B1660?

For B1660, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1660 without repair?

You can clear B1660 temporarily, but the code usually returns until the underlying fault is corrected.