B1680 is triggered when monitoring logic identifies an issue with Alarm Panic Input Circuit Short To Ground affecting body electronics and comfort modules.
B1680 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- related warning lamp illuminated
- battery draw complaints
- feature inoperative intermittently
Common causes
- Open circuit in wiring affecting alarm panic input circuit short to ground
- Broken terminal inside harness
- Connector pin damage/corrosion or harness stress near related components
How to diagnose B1680
- Confirm B1680 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to alarm panic input circuit short to ground for obvious defects.
- Use a continuity test from module pin to component to identify opens/high resistance.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code B1680
Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.
Can you drive with B1680?
Most vehicles can be driven short-term with B1680, but postpone heavy load/highway driving until repaired.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (open) in the alarm panic input circuit short to ground circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify B1680 remains cleared under the conditions that originally set the code.
Fix options
- Repair open circuit and secure connector lock.
- Restore continuity and verify pin tension.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$160-$850
Common mistakes when diagnosing B1680
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
B1680 in common vehicles
B1680 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes B1680?
B1680 is commonly set by open faults affecting alarm panic input circuit short to ground.
How much does it cost to fix B1680?
For B1680, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.
Can I clear B1680 without repair?
You can clear B1680 temporarily, but the code usually returns until the underlying fault is corrected.