B1731 Code: Meaning, Symptoms, Causes & Fix

B1731

Overview

Code B1731 indicates a fault in Seat Driver Rear Down Switch Circuit Short To Battery, typically within body electronics and comfort modules.

Symptoms

  • feature inoperative intermittently
  • module resets or glitches
  • related warning lamp illuminated

Common causes

  • Broken terminal inside harness affecting seat driver rear down switch circuit short to battery
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose B1731

  1. Confirm B1731 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to seat driver rear down switch circuit short to battery for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1731

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1731?

Most vehicles can be driven short-term with B1731, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the seat driver rear down switch circuit short to battery circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify B1731 remains cleared under the conditions that originally set the code.

Fix options

  • Restore continuity and verify pin tension.
  • Repair open circuit and secure connector lock.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1731

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

B1731 in common vehicles

B1731 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1731?

B1731 is commonly set by open faults affecting seat driver rear down switch circuit short to battery.

How much does it cost to fix B1731?

For B1731, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1731 without repair?

You can clear B1731 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools