B1785 is triggered when monitoring logic identifies an issue with Mirror Passenger Up Circuit Short To Ground affecting body electronics and comfort modules.
B1785 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- feature inoperative intermittently
- module resets or glitches
- related warning lamp illuminated
Common causes
- Broken terminal inside harness affecting mirror passenger up circuit short to ground
- Open circuit in wiring
- Connector pin damage/corrosion or harness stress near related components
How to diagnose B1785
- Confirm B1785 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to mirror passenger up circuit short to ground for obvious defects.
- Use a continuity test from module pin to component to identify opens/high resistance.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code B1785
Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.
Can you drive with B1785?
Most vehicles can be driven short-term with B1785, but postpone heavy load/highway driving until repaired.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (open) in the mirror passenger up circuit short to ground circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify B1785 remains cleared under the conditions that originally set the code.
Fix options
- Clear corrosion and protect terminals.
- Restore continuity and verify pin tension.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$160-$850
Common mistakes when diagnosing B1785
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
B1785 in common vehicles
B1785 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes B1785?
B1785 is commonly set by open faults affecting mirror passenger up circuit short to ground.
How much does it cost to fix B1785?
For B1785, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.
Can I clear B1785 without repair?
You can clear B1785 temporarily, but the code usually returns until the underlying fault is corrected.