B1802 Code: Meaning, Symptoms, Causes & Fix

Overview

Code B1802 indicates a fault in Lamp Turn Signal Rear Output Circuit Failure, typically within body electronics and comfort modules.

Symptoms

battery draw complaints
related warning lamp illuminated
module resets or glitches

Common causes

Disconnected or loose connector affecting lamp turn signal rear output circuit failure
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose B1802

Confirm B1802 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to lamp turn signal rear output circuit failure for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1802

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1802?

Most vehicles can be driven short-term with B1802, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the lamp turn signal rear output circuit failure circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify B1802 remains cleared under the conditions that originally set the code.

Fix options

Clear corrosion and protect terminals.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1802

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

B1802 in common vehicles

B1802 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1802?

B1802 is commonly set by open faults affecting lamp turn signal rear output circuit failure.

How much does it cost to fix B1802?

For B1802, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1802 without repair?

You can clear B1802 temporarily, but the code usually returns until the underlying fault is corrected.