When B1874 appears, the control module has detected abnormal behavior related to Cellular Phone Handset Not Present in body electronics and comfort modules.
B1874 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- feature inoperative intermittently
- module resets or glitches
- related warning lamp illuminated
Common causes
- Control module logic or calibration issue affecting cellular phone handset not present
- Component failure in the monitored system
- Connector pin damage/corrosion or harness stress near related components
How to diagnose B1874
- Confirm B1874 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to cellular phone handset not present for obvious defects.
- Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code B1874
Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.
Can you drive with B1874?
The vehicle is often drivable with B1874, but plan a repair window to prevent repeat faults.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (generic) in the cellular phone handset not present circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify B1874 remains cleared under the conditions that originally set the code.
Fix options
- Inspect circuit and connector condition.
- Test component operation and replace if faulty.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$90-$400
Common mistakes when diagnosing B1874
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
B1874 in common vehicles
B1874 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes B1874?
B1874 is commonly set by generic faults affecting cellular phone handset not present.
How much does it cost to fix B1874?
For B1874, repair costs are typically $90-$400 depending on exact root cause, labor rates, and part quality.
Can I clear B1874 without repair?
You can clear B1874 temporarily, but the code usually returns until the underlying fault is corrected.