B1887 Code: Meaning, Symptoms, Causes & Fix

B1887

Overview

B1887 is triggered when monitoring logic identifies an issue with Air Bag Driver Circuit Resistance Low or Shorted Together affecting body electronics and comfort modules.

Symptoms

  • battery draw complaints
  • related warning lamp illuminated
  • module resets or glitches

Common causes

  • Open circuit in wiring affecting air bag driver circuit resistance low or shorted together
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose B1887

  1. Confirm B1887 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to air bag driver circuit resistance low or shorted together for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B1887

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B1887?

Most vehicles can be driven short-term with B1887, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the air bag driver circuit resistance low or shorted together circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify B1887 remains cleared under the conditions that originally set the code.

Fix options

  • Clear corrosion and protect terminals.
  • Restore continuity and verify pin tension.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B1887

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

B1887 in common vehicles

B1887 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B1887?

B1887 is commonly set by open faults affecting air bag driver circuit resistance low or shorted together.

How much does it cost to fix B1887?

For B1887, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B1887 without repair?

You can clear B1887 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools