B2167 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• feature inoperative intermittently
• module resets or glitches
• related warning lamp illuminated

Common causes

• Electrical fault in the affected circuit affecting seat horizontal motor memory position out of range
• Component failure in the monitored system
• Connector pin damage/corrosion or harness stress near related components

How to diagnose B2167

1. Confirm B2167 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to seat horizontal motor memory position out of range for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B2167

Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.

Can you drive with B2167?

The vehicle is often drivable with B2167, but plan a repair window to prevent repeat faults.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the seat horizontal motor memory position out of range circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify B2167 remains cleared under the conditions that originally set the code.

Fix options

• Test component operation and replace if faulty.
• Inspect circuit and connector condition.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$90-$400

Common mistakes when diagnosing B2167

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

B2167 in common vehicles

B2167 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B2167?

B2167 is commonly set by generic faults affecting seat horizontal motor memory position out of range.

How much does it cost to fix B2167?

For B2167, repair costs are typically $90-$400 depending on exact root cause, labor rates, and part quality.

Can I clear B2167 without repair?

You can clear B2167 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost