B2246 Code: Meaning, Symptoms, Causes & Fix

B2246

Overview

B2246 is triggered when monitoring logic identifies an issue with Passenger Sliding Door Ajar Circuit Short to GND affecting body electronics and comfort modules.

Symptoms

  • battery draw complaints
  • related warning lamp illuminated
  • module resets or glitches

Common causes

  • Disconnected or loose connector affecting passenger sliding door ajar circuit short to gnd
  • Broken terminal inside harness
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose B2246

  1. Confirm B2246 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to passenger sliding door ajar circuit short to gnd for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code B2246

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with B2246?

Most vehicles can be driven short-term with B2246, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the passenger sliding door ajar circuit short to gnd circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify B2246 remains cleared under the conditions that originally set the code.

Fix options

  • Repair open circuit and secure connector lock.
  • Restore continuity and verify pin tension.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$160-$850

Common mistakes when diagnosing B2246

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

B2246 in common vehicles

B2246 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes B2246?

B2246 is commonly set by open faults affecting passenger sliding door ajar circuit short to gnd.

How much does it cost to fix B2246?

For B2246, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.

Can I clear B2246 without repair?

You can clear B2246 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools