C1103 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• chassis warning indicator
• reduced stability control performance
• longer braking intervention

Common causes

• Disconnected or loose connector affecting abs hydraulic brake switch circuit failure
• Broken terminal inside harness
• Connector pin damage/corrosion or harness stress near related components

How to diagnose C1103

1. Confirm C1103 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to abs hydraulic brake switch circuit failure for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code C1103

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with C1103?

Most vehicles can be driven short-term with C1103, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the abs hydraulic brake switch circuit failure circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify C1103 remains cleared under the conditions that originally set the code.

Fix options

• Clear corrosion and protect terminals.
• Restore continuity and verify pin tension.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$240-$1200

Common mistakes when diagnosing C1103

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

C1103 in common vehicles

C1103 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes C1103?

C1103 is commonly set by open faults affecting abs hydraulic brake switch circuit failure.

How much does it cost to fix C1103?

For C1103, repair costs are typically $240-$1200 depending on exact root cause, labor rates, and part quality.

Can I clear C1103 without repair?

You can clear C1103 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost