C1172 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• ABS/traction light on
• longer braking intervention
• reduced stability control performance

Common causes

• Open circuit in wiring affecting park brake switch # 1 applied circuit failure
• Broken terminal inside harness
• Connector pin damage/corrosion or harness stress near related components

How to diagnose C1172

1. Confirm C1172 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to park brake switch # 1 applied circuit failure for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code C1172

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with C1172?

Most vehicles can be driven short-term with C1172, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the park brake switch # 1 applied circuit failure circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify C1172 remains cleared under the conditions that originally set the code.

Fix options

• Restore continuity and verify pin tension.
• Clear corrosion and protect terminals.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$240-$1200

Common mistakes when diagnosing C1172

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

C1172 in common vehicles

C1172 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes C1172?

C1172 is commonly set by open faults affecting park brake switch # 1 applied circuit failure.

How much does it cost to fix C1172?

For C1172, repair costs are typically $240-$1200 depending on exact root cause, labor rates, and part quality.

Can I clear C1172 without repair?

You can clear C1172 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost