C1174 Code: Meaning, Symptoms, Causes & Fix

Overview

Code C1174 indicates a fault in Park Brake Switch # 2 Applied Circuit Failure, typically within ABS/chassis dynamics and brake control.

Symptoms

reduced stability control performance
chassis warning indicator
ABS/traction light on

Common causes

Disconnected or loose connector affecting park brake switch # 2 applied circuit failure
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose C1174

Confirm C1174 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to park brake switch # 2 applied circuit failure for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code C1174

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with C1174?

Most vehicles can be driven short-term with C1174, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the park brake switch # 2 applied circuit failure circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify C1174 remains cleared under the conditions that originally set the code.

Fix options

Repair open circuit and secure connector lock.
Clear corrosion and protect terminals.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$240-$1200

Common mistakes when diagnosing C1174

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

C1174 in common vehicles

C1174 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes C1174?

C1174 is commonly set by open faults affecting park brake switch # 2 applied circuit failure.

How much does it cost to fix C1174?

For C1174, repair costs are typically $240-$1200 depending on exact root cause, labor rates, and part quality.

Can I clear C1174 without repair?

You can clear C1174 temporarily, but the code usually returns until the underlying fault is corrected.