C1425 Code: Meaning, Symptoms, Causes & Fix

C1425

Overview

When C1425 appears, the control module has detected abnormal behavior related to Damper RR Circuit Short to Ground in ABS/chassis dynamics and brake control.

Symptoms

  • chassis warning indicator
  • reduced stability control performance
  • longer braking intervention

Common causes

  • Open circuit in wiring affecting damper rr circuit short to ground
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose C1425

  1. Confirm C1425 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to damper rr circuit short to ground for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code C1425

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with C1425?

Most vehicles can be driven short-term with C1425, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the damper rr circuit short to ground circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify C1425 remains cleared under the conditions that originally set the code.

Fix options

  • Restore continuity and verify pin tension.
  • Repair open circuit and secure connector lock.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$240-$1200

Common mistakes when diagnosing C1425

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

C1425 in common vehicles

C1425 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes C1425?

C1425 is commonly set by open faults affecting damper rr circuit short to ground.

How much does it cost to fix C1425?

For C1425, repair costs are typically $240-$1200 depending on exact root cause, labor rates, and part quality.

Can I clear C1425 without repair?

You can clear C1425 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools