C1935 Code: Meaning, Symptoms, Causes & Fix

Overview

C1935 is triggered when monitoring logic identifies an issue with Chime Circuit Failure affecting ABS/chassis dynamics and brake control.

Symptoms

longer braking intervention
ABS/traction light on
chassis warning indicator

Common causes

Disconnected or loose connector affecting chime circuit failure
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose C1935

Confirm C1935 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to chime circuit failure for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code C1935

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with C1935?

Most vehicles can be driven short-term with C1935, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the chime circuit failure circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify C1935 remains cleared under the conditions that originally set the code.

Fix options

Clear corrosion and protect terminals.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$240-$1200

Common mistakes when diagnosing C1935

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

C1935 in common vehicles

C1935 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes C1935?

C1935 is commonly set by open faults affecting chime circuit failure.

How much does it cost to fix C1935?

For C1935, repair costs are typically $240-$1200 depending on exact root cause, labor rates, and part quality.

Can I clear C1935 without repair?

You can clear C1935 temporarily, but the code usually returns until the underlying fault is corrected.