P0006 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P0006 indicates a fault in Fuel Shutoff Valve Control Circuit Low, typically within fuel delivery and pressure control.

Symptoms

engine may stall at idle
hard starting
reduced fuel economy

Common causes

Broken terminal inside harness affecting fuel shutoff valve control circuit low
Disconnected or loose connector
Connector pin damage/corrosion or harness stress near related components

How to diagnose P0006

Confirm P0006 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to fuel shutoff valve control circuit low for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0006

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0006?

Most vehicles can be driven short-term with P0006, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the fuel shutoff valve control circuit low circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P0006 remains cleared under the conditions that originally set the code.

Fix options

Repair open circuit and secure connector lock.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$220-$1100

Common mistakes when diagnosing P0006

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P0006 in common vehicles

P0006 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0006?

P0006 is commonly set by open faults affecting fuel shutoff valve control circuit low.

How much does it cost to fix P0006?

For P0006, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.

Can I clear P0006 without repair?

You can clear P0006 temporarily, but the code usually returns until the underlying fault is corrected.