P0022 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• loss of power at mid/high RPM
• engine noise or unstable timing
• rough running or misfire

Common causes

• Control module logic or calibration issue affecting intake camshaft position timing - over-retarded (bank 2)
• Component failure in the monitored system
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0022

1. Confirm P0022 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to intake camshaft position timing - over-retarded (bank 2) for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0022

Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.

Can you drive with P0022?

The vehicle is often drivable with P0022, but plan a repair window to prevent repeat faults.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the intake camshaft position timing - over-retarded (bank 2) circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0022 remains cleared under the conditions that originally set the code.

Fix options

• Clear code and confirm through drive cycle.
• Test component operation and replace if faulty.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$180-$700

Common mistakes when diagnosing P0022

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0022 in common vehicles

P0022 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0022?

P0022 is commonly set by generic faults affecting intake camshaft position timing - over-retarded (bank 2).

How much does it cost to fix P0022?

For P0022, repair costs are typically $180-$700 depending on exact root cause, labor rates, and part quality.

Can I clear P0022 without repair?

You can clear P0022 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost