P0077 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• reduced performance
• increased fuel use
• check engine light

Common causes

• Disconnected or loose connector affecting intake valve control circuit high (bank 2)
• Open circuit in wiring
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0077

1. Confirm P0077 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to intake valve control circuit high (bank 2) for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0077

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0077?

Most vehicles can be driven short-term with P0077, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the intake valve control circuit high (bank 2) circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0077 remains cleared under the conditions that originally set the code.

Fix options

• Restore continuity and verify pin tension.
• Repair open circuit and secure connector lock.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0077

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0077 in common vehicles

P0077 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0077?

P0077 is commonly set by open faults affecting intake valve control circuit high (bank 2).

How much does it cost to fix P0077?

For P0077, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0077 without repair?

You can clear P0077 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost