P0092 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P0092 indicates a fault in Fuel Pressure Regulator Control Circuit High, typically within fuel delivery and pressure control.

Symptoms

reduced fuel economy
hesitation under acceleration
engine may stall at idle

Common causes

Open circuit in wiring affecting fuel pressure regulator control circuit high
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose P0092

Confirm P0092 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to fuel pressure regulator control circuit high for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0092

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0092?

Most vehicles can be driven short-term with P0092, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the fuel pressure regulator control circuit high circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P0092 remains cleared under the conditions that originally set the code.

Fix options

Restore continuity and verify pin tension.
Clear corrosion and protect terminals.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$220-$1100

Common mistakes when diagnosing P0092

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P0092 in common vehicles

P0092 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0092?

P0092 is commonly set by open faults affecting fuel pressure regulator control circuit high.

How much does it cost to fix P0092?

For P0092, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.

Can I clear P0092 without repair?

You can clear P0092 temporarily, but the code usually returns until the underlying fault is corrected.