P0137 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• check engine light
• rough operation in certain conditions
• reduced performance

Common causes

• Open circuit in wiring affecting o2 sensor circuit low voltage (bank 1 sensor 2)
• Broken terminal inside harness
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0137

1. Confirm P0137 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to o2 sensor circuit low voltage (bank 1 sensor 2) for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0137

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0137?

Most vehicles can be driven short-term with P0137, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the o2 sensor circuit low voltage (bank 1 sensor 2) circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0137 remains cleared under the conditions that originally set the code.

Fix options

• Clear corrosion and protect terminals.
• Repair open circuit and secure connector lock.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0137

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0137 in common vehicles

P0137 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0137?

P0137 is commonly set by open faults affecting o2 sensor circuit low voltage (bank 1 sensor 2).

How much does it cost to fix P0137?

For P0137, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0137 without repair?

You can clear P0137 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost