P0192 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• hesitation under acceleration
• reduced fuel economy
• hard starting

Common causes

• Broken terminal inside harness affecting fuel rail pressure sensor circuit low input
• Open circuit in wiring
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0192

1. Confirm P0192 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to fuel rail pressure sensor circuit low input for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0192

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0192?

Most vehicles can be driven short-term with P0192, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the fuel rail pressure sensor circuit low input circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0192 remains cleared under the conditions that originally set the code.

Fix options

• Clear corrosion and protect terminals.
• Restore continuity and verify pin tension.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$220-$1100

Common mistakes when diagnosing P0192

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0192 in common vehicles

P0192 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0192?

P0192 is commonly set by open faults affecting fuel rail pressure sensor circuit low input.

How much does it cost to fix P0192?

For P0192, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.

Can I clear P0192 without repair?

You can clear P0192 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost