P0204 Code: Meaning, Symptoms, Causes & Fix

P0204

Overview

P0204 is triggered when monitoring logic identifies an issue with Injector Circuit Malfunction - Cylinder 4 affecting fuel delivery and pressure control.

Symptoms

  • hard starting
  • engine may stall at idle
  • hesitation under acceleration

Common causes

  • Broken terminal inside harness affecting injector circuit malfunction - cylinder 4
  • Open circuit in wiring
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P0204

  1. Confirm P0204 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to injector circuit malfunction - cylinder 4 for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0204

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0204?

Most vehicles can be driven short-term with P0204, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the injector circuit malfunction - cylinder 4 circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P0204 remains cleared under the conditions that originally set the code.

Fix options

  • Restore continuity and verify pin tension.
  • Repair open circuit and secure connector lock.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$220-$1100

Common mistakes when diagnosing P0204

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P0204 in common vehicles

P0204 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0204?

P0204 is commonly set by open faults affecting injector circuit malfunction - cylinder 4.

How much does it cost to fix P0204?

For P0204, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.

Can I clear P0204 without repair?

You can clear P0204 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools