P0332 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• rough operation in certain conditions
• check engine light
• increased fuel use

Common causes

• Broken terminal inside harness affecting knock sensor 2 circuit low input (bank 2)
• Open circuit in wiring
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0332

1. Confirm P0332 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to knock sensor 2 circuit low input (bank 2) for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0332

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0332?

Most vehicles can be driven short-term with P0332, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the knock sensor 2 circuit low input (bank 2) circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0332 remains cleared under the conditions that originally set the code.

Fix options

• Repair open circuit and secure connector lock.
• Clear corrosion and protect terminals.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0332

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0332 in common vehicles

P0332 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0332?

P0332 is commonly set by open faults affecting knock sensor 2 circuit low input (bank 2).

How much does it cost to fix P0332?

For P0332, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0332 without repair?

You can clear P0332 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost