P0547 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P0547 indicates a fault in Exhaust Gas Temperature Sensor Circuit - Bank 2 Sensor 1, typically within powertrain controls.

Symptoms

check engine light
rough operation in certain conditions
reduced performance

Common causes

Open circuit in wiring affecting exhaust gas temperature sensor circuit - bank 2 sensor 1
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose P0547

Confirm P0547 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to exhaust gas temperature sensor circuit - bank 2 sensor 1 for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0547

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0547?

Most vehicles can be driven short-term with P0547, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the exhaust gas temperature sensor circuit - bank 2 sensor 1 circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P0547 remains cleared under the conditions that originally set the code.

Fix options

Clear corrosion and protect terminals.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0547

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P0547 in common vehicles

P0547 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0547?

P0547 is commonly set by open faults affecting exhaust gas temperature sensor circuit - bank 2 sensor 1.

How much does it cost to fix P0547?

For P0547, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0547 without repair?

You can clear P0547 temporarily, but the code usually returns until the underlying fault is corrected.