P0627 Code: Meaning, Symptoms, Causes & Fix

P0627

Overview

When P0627 appears, the control module has detected abnormal behavior related to Fuel Pump A Control Circuit / Open in fuel delivery and pressure control.

Symptoms

  • hesitation under acceleration
  • reduced fuel economy
  • hard starting

Common causes

  • Broken terminal inside harness affecting fuel pump a control circuit / open
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P0627

  1. Confirm P0627 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to fuel pump a control circuit / open for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0627

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0627?

Most vehicles can be driven short-term with P0627, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the fuel pump a control circuit / open circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P0627 remains cleared under the conditions that originally set the code.

Fix options

  • Repair open circuit and secure connector lock.
  • Clear corrosion and protect terminals.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$220-$1100

Common mistakes when diagnosing P0627

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P0627 in common vehicles

P0627 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0627?

P0627 is commonly set by open faults affecting fuel pump a control circuit / open.

How much does it cost to fix P0627?

For P0627, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.

Can I clear P0627 without repair?

You can clear P0627 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools