P0707 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• reduced acceleration
• harsh or delayed shifting
• transmission warning message

Common causes

• Disconnected or loose connector affecting transmission range sensor circuit low input
• Broken terminal inside harness
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0707

1. Confirm P0707 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to transmission range sensor circuit low input for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0707

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0707?

Most vehicles can be driven short-term with P0707, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the transmission range sensor circuit low input circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0707 remains cleared under the conditions that originally set the code.

Fix options

• Restore continuity and verify pin tension.
• Clear corrosion and protect terminals.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$300-$1500

Common mistakes when diagnosing P0707

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0707 in common vehicles

P0707 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0707?

P0707 is commonly set by open faults affecting transmission range sensor circuit low input.

How much does it cost to fix P0707?

For P0707, repair costs are typically $300-$1500 depending on exact root cause, labor rates, and part quality.

Can I clear P0707 without repair?

You can clear P0707 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost