P0718 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• increased fuel use
• reduced performance
• rough operation in certain conditions

Common causes

• Temperature/vibration related circuit dropout affecting input/turbine speed sensor circuit intermittent
• Connector pin fit issue
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0718

1. Confirm P0718 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to input/turbine speed sensor circuit intermittent for obvious defects.
3. Reproduce the fault with harness movement and heat/vibration checks.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0718

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0718?

Most vehicles can be driven short-term with P0718, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (intermittent) in the input/turbine speed sensor circuit intermittent circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0718 remains cleared under the conditions that originally set the code.

Fix options

• Retest after thermal/vibration simulation.
• Wiggle-test harness during live monitoring.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0718

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0718 in common vehicles

P0718 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0718?

P0718 is commonly set by intermittent faults affecting input/turbine speed sensor circuit intermittent.

How much does it cost to fix P0718?

For P0718, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0718 without repair?

You can clear P0718 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost