P0724 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• gear hunting
• transmission warning message
• harsh or delayed shifting

Common causes

• Open circuit in wiring affecting torque converter/brake switch b circuit high
• Disconnected or loose connector
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P0724

1. Confirm P0724 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to torque converter/brake switch b circuit high for obvious defects.
3. Use a continuity test from module pin to component to identify opens/high resistance.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0724

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0724?

Most vehicles can be driven short-term with P0724, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (open) in the torque converter/brake switch b circuit high circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P0724 remains cleared under the conditions that originally set the code.

Fix options

• Clear corrosion and protect terminals.
• Restore continuity and verify pin tension.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$300-$1500

Common mistakes when diagnosing P0724

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P0724 in common vehicles

P0724 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0724?

P0724 is commonly set by open faults affecting torque converter/brake switch b circuit high.

How much does it cost to fix P0724?

For P0724, repair costs are typically $300-$1500 depending on exact root cause, labor rates, and part quality.

Can I clear P0724 without repair?

You can clear P0724 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost