P0738 Code: Meaning, Symptoms, Causes & Fix

Overview

P0738 is triggered when monitoring logic identifies an issue with TCM Engine Speed Output Circuit Low affecting powertrain controls.

Symptoms

rough operation in certain conditions
check engine light
increased fuel use

Common causes

Open circuit in wiring affecting tcm engine speed output circuit low
Disconnected or loose connector
Connector pin damage/corrosion or harness stress near related components

How to diagnose P0738

Confirm P0738 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to tcm engine speed output circuit low for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0738

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0738?

Most vehicles can be driven short-term with P0738, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the tcm engine speed output circuit low circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P0738 remains cleared under the conditions that originally set the code.

Fix options

Clear corrosion and protect terminals.
Restore continuity and verify pin tension.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0738

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P0738 in common vehicles

P0738 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0738?

P0738 is commonly set by open faults affecting tcm engine speed output circuit low.

How much does it cost to fix P0738?

For P0738, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0738 without repair?

You can clear P0738 temporarily, but the code usually returns until the underlying fault is corrected.