P0873 Code: Meaning, Symptoms, Causes & Fix

P0873

Overview

Code P0873 indicates a fault in Transmission Fluid Pressure Sensor/Switch C Circuit High, typically within transmission and shift management.

Symptoms

  • reduced acceleration
  • harsh or delayed shifting
  • transmission warning message

Common causes

  • Broken terminal inside harness affecting transmission fluid pressure sensor/switch c circuit high
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P0873

  1. Confirm P0873 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to transmission fluid pressure sensor/switch c circuit high for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0873

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0873?

Most vehicles can be driven short-term with P0873, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the transmission fluid pressure sensor/switch c circuit high circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P0873 remains cleared under the conditions that originally set the code.

Fix options

  • Restore continuity and verify pin tension.
  • Clear corrosion and protect terminals.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$300-$1500

Common mistakes when diagnosing P0873

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P0873 in common vehicles

P0873 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0873?

P0873 is commonly set by open faults affecting transmission fluid pressure sensor/switch c circuit high.

How much does it cost to fix P0873?

For P0873, repair costs are typically $300-$1500 depending on exact root cause, labor rates, and part quality.

Can I clear P0873 without repair?

You can clear P0873 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools