P0898 Code: Meaning, Symptoms, Causes & Fix

P0898

Overview

P0898 is triggered when monitoring logic identifies an issue with Transmission Control System MIL Request Circuit Low affecting transmission and shift management.

Symptoms

  • harsh or delayed shifting
  • reduced acceleration
  • gear hunting

Common causes

  • Open circuit in wiring affecting transmission control system mil request circuit low
  • Disconnected or loose connector
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P0898

  1. Confirm P0898 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to transmission control system mil request circuit low for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0898

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0898?

Most vehicles can be driven short-term with P0898, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the transmission control system mil request circuit low circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P0898 remains cleared under the conditions that originally set the code.

Fix options

  • Repair open circuit and secure connector lock.
  • Clear corrosion and protect terminals.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$300-$1500

Common mistakes when diagnosing P0898

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P0898 in common vehicles

P0898 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0898?

P0898 is commonly set by open faults affecting transmission control system mil request circuit low.

How much does it cost to fix P0898?

For P0898, repair costs are typically $300-$1500 depending on exact root cause, labor rates, and part quality.

Can I clear P0898 without repair?

You can clear P0898 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools