P0967 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P0967 indicates a fault in Pressure Control Solenoid B Control Circuit High, typically within powertrain controls.

Symptoms

rough operation in certain conditions
check engine light
increased fuel use

Common causes

Broken terminal inside harness affecting pressure control solenoid b control circuit high
Open circuit in wiring
Connector pin damage/corrosion or harness stress near related components

How to diagnose P0967

Confirm P0967 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to pressure control solenoid b control circuit high for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P0967

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P0967?

Most vehicles can be driven short-term with P0967, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the pressure control solenoid b control circuit high circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P0967 remains cleared under the conditions that originally set the code.

Fix options

Repair open circuit and secure connector lock.
Clear corrosion and protect terminals.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P0967

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P0967 in common vehicles

P0967 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P0967?

P0967 is commonly set by open faults affecting pressure control solenoid b control circuit high.

How much does it cost to fix P0967?

For P0967, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P0967 without repair?

You can clear P0967 temporarily, but the code usually returns until the underlying fault is corrected.