P1112 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• reduced performance
• increased fuel use
• check engine light

Common causes

• Intermittent harness contact affecting intake air temperature (iat) sensor circuit intermittent low voltage
• Connector pin fit issue
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P1112

1. Confirm P1112 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to intake air temperature (iat) sensor circuit intermittent low voltage for obvious defects.
3. Reproduce the fault with harness movement and heat/vibration checks.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1112

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P1112?

Most vehicles can be driven short-term with P1112, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (intermittent) in the intake air temperature (iat) sensor circuit intermittent low voltage circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P1112 remains cleared under the conditions that originally set the code.

Fix options

• Repair intermittent connector contact.
• Retest after thermal/vibration simulation.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P1112

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P1112 in common vehicles

P1112 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1112?

P1112 is commonly set by intermittent faults affecting intake air temperature (iat) sensor circuit intermittent low voltage.

How much does it cost to fix P1112?

For P1112, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P1112 without repair?

You can clear P1112 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost