P1141 is triggered when monitoring logic identifies an issue with Fuel Restriction Indicator Circuit Malfunction affecting fuel delivery and pressure control.
P1141 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- hard starting
- engine may stall at idle
- hesitation under acceleration
Common causes
- Open circuit in wiring affecting fuel restriction indicator circuit malfunction
- Broken terminal inside harness
- Connector pin damage/corrosion or harness stress near related components
How to diagnose P1141
- Confirm P1141 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to fuel restriction indicator circuit malfunction for obvious defects.
- Use a continuity test from module pin to component to identify opens/high resistance.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code P1141
Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.
Can you drive with P1141?
Most vehicles can be driven short-term with P1141, but postpone heavy load/highway driving until repaired.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (open) in the fuel restriction indicator circuit malfunction circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify P1141 remains cleared under the conditions that originally set the code.
Fix options
- Clear corrosion and protect terminals.
- Restore continuity and verify pin tension.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$220-$1100
Common mistakes when diagnosing P1141
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
P1141 in common vehicles
P1141 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes P1141?
P1141 is commonly set by open faults affecting fuel restriction indicator circuit malfunction.
How much does it cost to fix P1141?
For P1141, repair costs are typically $220-$1100 depending on exact root cause, labor rates, and part quality.
Can I clear P1141 without repair?
You can clear P1141 temporarily, but the code usually returns until the underlying fault is corrected.