P1277 Code: Meaning, Symptoms, Causes & Fix

Overview

When P1277 appears, the control module has detected abnormal behavior related to Cylinder #7 High To Low Side Open in powertrain controls.

Symptoms

increased fuel use
reduced performance
rough operation in certain conditions

Common causes

Disconnected or loose connector affecting cylinder #7 high to low side open
Broken terminal inside harness
Connector pin damage/corrosion or harness stress near related components

How to diagnose P1277

Confirm P1277 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to cylinder #7 high to low side open for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1277

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P1277?

Most vehicles can be driven short-term with P1277, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the cylinder #7 high to low side open circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P1277 remains cleared under the conditions that originally set the code.

Fix options

Restore continuity and verify pin tension.
Repair open circuit and secure connector lock.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P1277

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P1277 in common vehicles

P1277 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1277?

P1277 is commonly set by open faults affecting cylinder #7 high to low side open.

How much does it cost to fix P1277?

For P1277, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P1277 without repair?

You can clear P1277 temporarily, but the code usually returns until the underlying fault is corrected.