P1314 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• failed emissions test readiness
• rough idle under load
• check engine light

Common causes

• Electrical fault in the affected circuit affecting misfire rate catalyst damage fault - bank 2
• Component failure in the monitored system
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P1314

1. Confirm P1314 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to misfire rate catalyst damage fault - bank 2 for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1314

High: This code is high severity because the affected system can directly impact drivability, safety, or catalyst/engine protection.

Can you drive with P1314?

Driving with P1314 should be limited to a short trip for diagnosis/repair. Continued driving can cause expensive secondary damage.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the misfire rate catalyst damage fault - bank 2 circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P1314 remains cleared under the conditions that originally set the code.

Fix options

• Inspect circuit and connector condition.
• Clear code and confirm through drive cycle.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$350-$1800

Common mistakes when diagnosing P1314

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P1314 in common vehicles

P1314 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1314?

P1314 is commonly set by generic faults affecting misfire rate catalyst damage fault - bank 2.

How much does it cost to fix P1314?

For P1314, repair costs are typically $350-$1800 depending on exact root cause, labor rates, and part quality.

Can I clear P1314 without repair?

You can clear P1314 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost