P1380 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• check engine light
• rough operation in certain conditions
• reduced performance

Common causes

• Component failure in the monitored system affecting misfire detected - rough road data not available
• Electrical fault in the affected circuit
• Connector pin damage/corrosion or harness stress near related components

How to diagnose P1380

1. Confirm P1380 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to misfire detected - rough road data not available for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1380

High: This code is high severity because the affected system can directly impact drivability, safety, or catalyst/engine protection.

Can you drive with P1380?

Driving with P1380 should be limited to a short trip for diagnosis/repair. Continued driving can cause expensive secondary damage.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the misfire detected - rough road data not available circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify P1380 remains cleared under the conditions that originally set the code.

Fix options

• Test component operation and replace if faulty.
• Clear code and confirm through drive cycle.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$400-$2000

Common mistakes when diagnosing P1380

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

P1380 in common vehicles

P1380 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1380?

P1380 is commonly set by generic faults affecting misfire detected - rough road data not available.

How much does it cost to fix P1380?

For P1380, repair costs are typically $400-$2000 depending on exact root cause, labor rates, and part quality.

Can I clear P1380 without repair?

You can clear P1380 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost