P1401 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P1401 indicates a fault in DPFE Circuit High Input, typically within powertrain controls.

Symptoms

increased fuel use
reduced performance
rough operation in certain conditions

Common causes

Disconnected or loose connector affecting dpfe circuit high input
Open circuit in wiring
Connector pin damage/corrosion or harness stress near related components

How to diagnose P1401

Confirm P1401 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to dpfe circuit high input for obvious defects.
Use a continuity test from module pin to component to identify opens/high resistance.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1401

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P1401?

Most vehicles can be driven short-term with P1401, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (open) in the dpfe circuit high input circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P1401 remains cleared under the conditions that originally set the code.

Fix options

Restore continuity and verify pin tension.
Clear corrosion and protect terminals.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P1401

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P1401 in common vehicles

P1401 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1401?

P1401 is commonly set by open faults affecting dpfe circuit high input.

How much does it cost to fix P1401?

For P1401, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P1401 without repair?

You can clear P1401 temporarily, but the code usually returns until the underlying fault is corrected.