P1464 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P1464 indicates a fault in A/C Demand Out of Self Test Range, typically within powertrain controls.

Symptoms

rough operation in certain conditions
check engine light
increased fuel use

Common causes

Electrical fault in the affected circuit affecting a/c demand out of self test range
Component failure in the monitored system
Connector pin damage/corrosion or harness stress near related components

How to diagnose P1464

Confirm P1464 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to a/c demand out of self test range for obvious defects.
Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1464

Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.

Can you drive with P1464?

The vehicle is often drivable with P1464, but plan a repair window to prevent repeat faults.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (generic) in the a/c demand out of self test range circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P1464 remains cleared under the conditions that originally set the code.

Fix options

Test component operation and replace if faulty.
Inspect circuit and connector condition.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$100-$450

Common mistakes when diagnosing P1464

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P1464 in common vehicles

P1464 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1464?

P1464 is commonly set by generic faults affecting a/c demand out of self test range.

How much does it cost to fix P1464?

For P1464, repair costs are typically $100-$450 depending on exact root cause, labor rates, and part quality.

Can I clear P1464 without repair?

You can clear P1464 temporarily, but the code usually returns until the underlying fault is corrected.