P1487 Code: Meaning, Symptoms, Causes & Fix

P1487

Overview

When P1487 appears, the control module has detected abnormal behavior related to EGRCHK Solenoid Circuit Malfunction in emissions and air-fuel control.

Symptoms

  • failed emissions test readiness
  • rough idle under load
  • check engine light

Common causes

  • Broken terminal inside harness affecting egrchk solenoid circuit malfunction
  • Open circuit in wiring
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P1487

  1. Confirm P1487 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to egrchk solenoid circuit malfunction for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1487

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P1487?

Most vehicles can be driven short-term with P1487, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the egrchk solenoid circuit malfunction circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P1487 remains cleared under the conditions that originally set the code.

Fix options

  • Clear corrosion and protect terminals.
  • Repair open circuit and secure connector lock.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$180-$900

Common mistakes when diagnosing P1487

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P1487 in common vehicles

P1487 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1487?

P1487 is commonly set by open faults affecting egrchk solenoid circuit malfunction.

How much does it cost to fix P1487?

For P1487, repair costs are typically $180-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P1487 without repair?

You can clear P1487 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools