P1660 Code: Meaning, Symptoms, Causes & Fix

P1660

Overview

When P1660 appears, the control module has detected abnormal behavior related to Output Circuit Check Signal High in powertrain controls.

Symptoms

  • reduced performance
  • increased fuel use
  • check engine light

Common causes

  • Disconnected or loose connector affecting output circuit check signal high
  • Broken terminal inside harness
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P1660

  1. Confirm P1660 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to output circuit check signal high for obvious defects.
  3. Use a continuity test from module pin to component to identify opens/high resistance.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1660

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with P1660?

Most vehicles can be driven short-term with P1660, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (open) in the output circuit check signal high circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P1660 remains cleared under the conditions that originally set the code.

Fix options

  • Restore continuity and verify pin tension.
  • Clear corrosion and protect terminals.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$200-$900

Common mistakes when diagnosing P1660

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P1660 in common vehicles

P1660 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1660?

P1660 is commonly set by open faults affecting output circuit check signal high.

How much does it cost to fix P1660?

For P1660, repair costs are typically $200-$900 depending on exact root cause, labor rates, and part quality.

Can I clear P1660 without repair?

You can clear P1660 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools