P1704 Code: Meaning, Symptoms, Causes & Fix

Overview

Code P1704 indicates a fault in Digital TRS Failed to Transition States in KOEO / KOER, typically within powertrain controls.

Symptoms

increased fuel use
reduced performance
rough operation in certain conditions

Common causes

Control module logic or calibration issue affecting digital trs failed to transition states in koeo / koer
Electrical fault in the affected circuit
Connector pin damage/corrosion or harness stress near related components

How to diagnose P1704

Confirm P1704 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to digital trs failed to transition states in koeo / koer for obvious defects.
Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1704

Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.

Can you drive with P1704?

The vehicle is often drivable with P1704, but plan a repair window to prevent repeat faults.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (generic) in the digital trs failed to transition states in koeo / koer circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify P1704 remains cleared under the conditions that originally set the code.

Fix options

Inspect circuit and connector condition.
Test component operation and replace if faulty.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$100-$450

Common mistakes when diagnosing P1704

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

P1704 in common vehicles

P1704 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1704?

P1704 is commonly set by generic faults affecting digital trs failed to transition states in koeo / koer.

How much does it cost to fix P1704?

For P1704, repair costs are typically $100-$450 depending on exact root cause, labor rates, and part quality.

Can I clear P1704 without repair?

You can clear P1704 temporarily, but the code usually returns until the underlying fault is corrected.