P1745 Code: Meaning, Symptoms, Causes & Fix

P1745

Overview

When P1745 appears, the control module has detected abnormal behavior related to Line Pressure Solenoid System in powertrain controls.

Symptoms

  • reduced performance
  • increased fuel use
  • check engine light

Common causes

  • Component failure in the monitored system affecting line pressure solenoid system
  • Control module logic or calibration issue
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose P1745

  1. Confirm P1745 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to line pressure solenoid system for obvious defects.
  3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code P1745

Low: This code is low to moderate severity in most cases, but diagnosis is still recommended to avoid recurring warnings.

Can you drive with P1745?

The vehicle is often drivable with P1745, but plan a repair window to prevent repeat faults.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (generic) in the line pressure solenoid system circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify P1745 remains cleared under the conditions that originally set the code.

Fix options

  • Inspect circuit and connector condition.
  • Clear code and confirm through drive cycle.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$100-$450

Common mistakes when diagnosing P1745

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

P1745 in common vehicles

P1745 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes P1745?

P1745 is commonly set by generic faults affecting line pressure solenoid system.

How much does it cost to fix P1745?

For P1745, repair costs are typically $100-$450 depending on exact root cause, labor rates, and part quality.

Can I clear P1745 without repair?

You can clear P1745 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools