U0112 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• feature communication timeout
• multiple warning lights at once
• intermittent no-start or limp mode

Common causes

• CAN bus wiring fault affecting lost communication with battery energy control module b
• Network termination or gateway fault
• Connector pin damage/corrosion or harness stress near related components

How to diagnose U0112

1. Confirm U0112 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to lost communication with battery energy control module b for obvious defects.
3. Check CAN high/low integrity, network termination resistance, and module wake-up status.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U0112

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U0112?

Most vehicles can be driven short-term with U0112, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (communication) in the lost communication with battery energy control module b circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify U0112 remains cleared under the conditions that originally set the code.

Fix options

• Stabilize voltage supply and module grounds.
• Repair CAN high/low wiring or termination issue.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U0112

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

U0112 in common vehicles

U0112 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U0112?

U0112 is commonly set by communication faults affecting lost communication with battery energy control module b.

How much does it cost to fix U0112?

For U0112, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U0112 without repair?

You can clear U0112 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost