U0142 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• module not responding in scan tool
• intermittent no-start or limp mode
• multiple warning lights at once

Common causes

• CAN bus wiring fault affecting lost communication with body control module b
• Network termination or gateway fault
• Connector pin damage/corrosion or harness stress near related components

How to diagnose U0142

1. Confirm U0142 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to lost communication with body control module b for obvious defects.
3. Check CAN high/low integrity, network termination resistance, and module wake-up status.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U0142

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U0142?

Most vehicles can be driven short-term with U0142, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (communication) in the lost communication with body control module b circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify U0142 remains cleared under the conditions that originally set the code.

Fix options

• Stabilize voltage supply and module grounds.
• Scan all modules for communication chain faults.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U0142

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

U0142 in common vehicles

U0142 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U0142?

U0142 is commonly set by communication faults affecting lost communication with body control module b.

How much does it cost to fix U0142?

For U0142, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U0142 without repair?

You can clear U0142 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost