U0162 Code: Meaning, Symptoms, Causes & Fix

Overview

Code U0162 indicates a fault in Lost Communication With Navigation Display Module, typically within module-to-module CAN communication.

Symptoms

multiple warning lights at once
feature communication timeout
module not responding in scan tool

Common causes

Network termination or gateway fault affecting lost communication with navigation display module
Module power/ground instability
Connector pin damage/corrosion or harness stress near related components

How to diagnose U0162

Confirm U0162 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to lost communication with navigation display module for obvious defects.
Check CAN high/low integrity, network termination resistance, and module wake-up status.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U0162

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U0162?

Most vehicles can be driven short-term with U0162, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (communication) in the lost communication with navigation display module circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify U0162 remains cleared under the conditions that originally set the code.

Fix options

Repair CAN high/low wiring or termination issue.
Stabilize voltage supply and module grounds.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U0162

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

U0162 in common vehicles

U0162 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U0162?

U0162 is commonly set by communication faults affecting lost communication with navigation display module.

How much does it cost to fix U0162?

For U0162, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U0162 without repair?

You can clear U0162 temporarily, but the code usually returns until the underlying fault is corrected.