U1058 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• reduced acceleration
• harsh or delayed shifting
• transmission warning message

Common causes

• Control module logic or calibration issue affecting scp (j1850) invalid or missing data for transmission / transaxle / prndl
• Component failure in the monitored system
• Connector pin damage/corrosion or harness stress near related components

How to diagnose U1058

1. Confirm U1058 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to scp (j1850) invalid or missing data for transmission / transaxle / prndl for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U1058

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U1058?

Most vehicles can be driven short-term with U1058, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the scp (j1850) invalid or missing data for transmission / transaxle / prndl circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify U1058 remains cleared under the conditions that originally set the code.

Fix options

• Test component operation and replace if faulty.
• Clear code and confirm through drive cycle.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$300-$1500

Common mistakes when diagnosing U1058

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

U1058 in common vehicles

U1058 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U1058?

U1058 is commonly set by generic faults affecting scp (j1850) invalid or missing data for transmission / transaxle / prndl.

How much does it cost to fix U1058?

For U1058, repair costs are typically $300-$1500 depending on exact root cause, labor rates, and part quality.

Can I clear U1058 without repair?

You can clear U1058 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost