U1087 Code: Meaning, Symptoms, Causes & Fix

Overview

Symptoms

• intermittent no-start or limp mode
• module not responding in scan tool
• feature communication timeout

Common causes

• Control module logic or calibration issue affecting scp (j1850) invalid or missing data for primary id
• Component failure in the monitored system
• Connector pin damage/corrosion or harness stress near related components

How to diagnose U1087

1. Confirm U1087 and capture freeze-frame data with a professional scan tool.
2. Inspect wiring, connectors, and grounds related to scp (j1850) invalid or missing data for primary id for obvious defects.
3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
4. Check for related DTCs to identify the root-cause chain before replacing parts.
5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U1087

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U1087?

Most vehicles can be driven short-term with U1087, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
2. Address the root fault mode (generic) in the scp (j1850) invalid or missing data for primary id circuit/system.
3. Apply the required relearn/adaptation procedure if specified by service information.
4. Road-test and verify U1087 remains cleared under the conditions that originally set the code.

Fix options

• Clear code and confirm through drive cycle.
• Test component operation and replace if faulty.
• Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U1087

• Replacing parts without verifying voltage, ground, and signal integrity first.
• Ignoring related stored/pending codes that indicate upstream faults.
• Skipping post-repair verification drive cycle and readiness checks.

U1087 in common vehicles

U1087 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U1087?

U1087 is commonly set by generic faults affecting scp (j1850) invalid or missing data for primary id.

How much does it cost to fix U1087?

For U1087, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U1087 without repair?

You can clear U1087 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools

• Estimate repair cost
• Decode your VIN
• Calculate fuel cost